AL-308 TR2 Overhead Anchor Rail System 8 m

The PGTEC TR2 is a heavy overhead anchor rail system spanning 8 m between structural columns, engineered to protect up to two workers performing work at height inside workshops, hangars, loading halls and plant rooms where a clear overhead runway is available. The silver anodised aluminium rail is suspended between the columns by galvanised brackets, and a ball-bearing trolley carries a short lanyard that follows the worker from one end of the run to the other. Navy-blue end stops close each end of the track, and the whole system is rated above 22 kN at the mounting points. Because the rail is rigid and overhead, the worker stays tied off even when moving across open floor space below, and the trolley offers so little resistance that operators barely notice it during normal work. The TR2 is specified for aircraft hangars, bus and truck workshops, shipyard fabrication halls and large maintenance bays where technicians must reach elevated equipment and overhead services without edge protection at floor level. The rail can be extended by adding spliced 4 m sections, and the supplied installation drawing fixes bracket spacing to the actual column grid. Each system is delivered with a trolley, end stops, brackets, fixings and a test certificate. The PGTEC TR2 is the professional overhead anchor rail that gives tall interior workspaces continuous, invisible fall protection.