AL-306 HL2K-Pro Horizontal Cable Lifeline Kit 25 m

The PGTEC HL2K-Pro is the extended-span version of the HL2K horizontal cable lifeline, built to protect up to two workers across a full 25 m route on large commercial and industrial roofs where a single continuous tie-off line is required. The professional kit includes heavier galvanized end anchorage units with navy-blue powder-coated cassettes, a higher-strength 8 mm steel cable, a mechanical tensioner, intermediate support posts for longer runs, an in-line energy absorber and two travelling rope grabs. Engineered to EN 795 and CEN TS 16415 with end anchor forces kept below 22 kN thanks to the dedicated absorber, the HL2K-Pro is designed for big-box retail roofs, distribution centres, refinery pipe racks and long factory aisles where teams must walk hundreds of metres along exposed edges. The intermediate posts keep the cable from sagging or interfering with rooftop plant, and the tensioner can be re-adjusted as the cable stretches over years of service. Because both rope grabs ride freely along the wire, two technicians can work the roof simultaneously without passing problems or losing protection. Each kit is supplied with an installation drawing, load calculations for typical roof decks, a test certificate and spare-part list. The PGTEC HL2K-Pro gives project engineers a certified, scalable horizontal lifeline that turns even the longest exposed roof into a safe, continuously protected walkway.